Arduino MATERIA 101 Manual de usuario descargar pdf (Pagina 48)

48

Assembly Manual

Arduino Materia 101

calIBRaTION

Fig. 5

If you choose Prepare -->Preheat

from the LCD menu you will see the

LCD temperature going up and the

frontal fan turning on.

From the “Prepare” menu you can

try to launch the “Change Filament”

command; the printer will heat up

and the axes will finding their home

position. When the printer is at the

correct temperature it will unload

the filament. The extruder motor

will run clockwise with a beeping

sound at the end. You must click the

knob to stop it. Now the motor is

running counter-clockwise. You can

insert a filament inside the extruder

by using just a bit of pressure.

IF YOU HAVE NOT ENCOUNTERED

ANY PROBLEMS SO FAR, YOU ARE

DOING A GREAT JOB!

Fig. 5

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 54 55

Comentarios a estos manuales

Sin comentarios